28 Users Online
Revision: 20140915_214235 | All Revisions
The #Steyr #AUG is manufactured in #Australia and is used by #military #forces all over the world. Being a bullpup, the longer barrel in a shorter overall length provides numerous advantages in airsoft. This article shows you how to disassemble the AUG airsoft rifle.
We are going to illustrate the disassembly process with the JG UA-3 RAS AEG. That is because the JG UA-3 RAS is a Steyr AUG A2/A3 variant with the quad-rail up front. It has one additional disassembly step compare to the A1 version. That extra step is the removal of the quad-rail.
There are two hex screws on the top front portion of the Picatinny rail (see photo below). Unscrew these two hex screws.
Then push the quad forward and remove it (see photo below).
From this point forward, the reset of the disassembly process applies to all airsoft AUG AEG's.
A Phillips screw (see photo below) on the bottom of the magazine, close to the winding wheel, allows you to take it apart.
Once you unscrew the Phillips screw, you can slide the bottom plate off the magazine. Then you can push the magazine insert upward and remove it from the top of the magazine (see photo below).
The following photo shows the disassembled pieces.
Fun for Photographers
Get Our
Memecoins!
