How to Remove the Selector Switch on JG MP5?

Add Comment | Related Links | TrackBack
Related Content

How to Remove the Selector Switch on JG MP5?

I have two JG MP5 airsoft guns: a JG M5-S6 and a JG M5-A5. I believe JG is the same brand as GB. Anyway, both of these MP5 airsoft electronic guns (AEG) are practically the same. Just the front end is somewhat different. So far, I haven't been able to figure out how to remove the mode selector switch on it (shown in the photo below).

It seems that it's a hex nut underneath. But none of my hex wrenches fit. They are either too big or too small. Does anyone know the right size for it?

Jake
Sat, 22 Feb 2014 02:28:41 +0300

Use a 1.3mm precision hex bit. I have gotten one at the Harbor Freight, because it is not common. 1.3mm hex bit is just slightly smaller than the set screw, but it works. 1.5mm hex bit is too big. 1.4mm bit may possibly fit better than 1.3mm.

Jacob
Tue, 25 Feb 2014 13:49:51 +0300

Add Comment | Related Links | TrackBack
Related Content

Did your message disappear? Read the Forums FAQ.

Add Comment

Spam Control | * indicates required field

TrackBack

TrackBack only accepted from WebSite-X Suite web sites. Do not submit TrackBacks from other sites.

Send Ping | TrackBack URL | Spam Control

No TrackBacks yet. TrackBack can be used to link this thread to your weblog, or link your weblog to this thread. In addition, TrackBack can be used as a form of remote commenting. Rather than posting the comment directly on this thread, you can posts it on your own weblog. Then have your weblog sends a TrackBack ping to the TrackBack URL, so that your post would show up here.

Your Name: *
E-mail:
	Remember Me!
Comment: *
	File attachment is optional. Please do not attach a file to your submission unless it is relevent.
Attach File: (20 MB Max)
Spam Protection: *	Answer of 2 + 8?
	Click button only once, please!