While reviewing the APS ASR107 M4 URX Raptor, I found that the top rail on the quad rail handguard doesn't line up with the upper receiver rail (see photo below) when I tighten it.
What is proper method to align the top rails on the handguard and the receiver? Do you use washers to shim the quad rail and the receiver? Or do you simply glue the two pieces together in the right position?
I'm against gluing it, because I won't be able to take it apart then.
Sat, 12 Oct 2013 02:01:40 +0400
I just learned about crush washers for muzzle brake on a AR today. Wikipedia describes a crush washer: "Crush washers are made of a soft metal such as aluminium or copper and are used to seal fluid or gas connections such as those found in an internal combustion engine."
Doesn't really quite describe it for this purpose, but a crush washer is basically a washer that will "crush-in" as you tighten on it. You can use it to align a flash suppressor, a muzzle brake, or a quad-rail. So that's probably what I need to use to get this quad rail to line up to the receiver.
Sat, 06 Sep 2014 01:41:35 +0400
Did your message disappear? Read the Forums FAQ.
Spam Control | * indicates required field
TrackBack only accepted from WebSite-X Suite web sites. Do not submit TrackBacks from other sites.
No TrackBacks yet. TrackBack can be used to link this thread to your weblog, or link your weblog to this thread. In addition, TrackBack can be used as a form of remote commenting. Rather than posting the comment directly on this thread, you can posts it on your own weblog. Then have your weblog sends a TrackBack ping to the TrackBack URL, so that your post would show up here.
Messages, files, and images copyright by respective owners.